Fast crueler help

Everything about the various Boulder Dash tools, and other stuff created by the fans.

Moderator: Admin

Post Reply
User avatar
Sendy
Member
Posts: 186
Joined: Sun Jun 17, 2007 10:33 pm
Location: Square Wave Heaven
Contact:

Fast crueler help

Post by Sendy »

It's asking me JUMP: (HEX)?

What do I put here? I've completely forgotten >_<

I don't understand the (S)EI OR (C)LI question either. What's that?

EDIT: Another question I don't understand: "SHALL THE CRUNCHER SET 2D/2E?"

I don't remember this part from last time I crunched..
Watcher Kitty is always watching...
User avatar
LogicDeLuxe
Member
Posts: 638
Joined: Sun Jul 15, 2007 12:52 pm
Contact:

Re: Fast crueler help

Post by LogicDeLuxe »

Sendy wrote:It's asking me JUMP: (HEX)?

What do I put here? I've completely forgotten >_<
Depends on the engine you are using. It should be stated on screen in the tool you're created your file with. And it should be mentioned in the manual for that tool also.
I don't understand the (S)EI OR (C)LI question either. What's that?

EDIT: Another question I don't understand: "SHALL THE CRUNCHER SET 2D/2E?"
Just choose anything.
The first is an assembler instruction added by the cruncher, but any BD engine sets it by itself, thus overriding the setting.
The latter is important for BASIC Kernel routines or code, which BD doesn't care for either.
User avatar
Sendy
Member
Posts: 186
Joined: Sun Jun 17, 2007 10:33 pm
Location: Square Wave Heaven
Contact:

Post by Sendy »

Got it, thanks.
Watcher Kitty is always watching...
Post Reply